No rebates currently available for this model.

Cooktop type

Gas cooktop

Width (in.)

90 cm

Total number of cooktop burners

5

Power of the heating elements

1 x 5.5 KW, 2 x 2.0 KW, 2 x 4.0 KW

Basic surface material

brushed stainless steel

Frame type

Standard design

Variant color

Stainless steel

Included accessories

1 x WOK attachment ring

Dimensions

165 x 908 x 520 mm

Minimum height for installation

134 mm

Maximum height for installation (in.)

134 mm

Minimum width for installation

886 mm

Maximum width for installation

888 mm

Depth for installation

491 mm

Cooktop-based hood control

No

Watts

15 W

Gas connection rating

17,500 W

Fuse protection

15 A

Volts

120 V

Power cord length

140 cm

Plug type

120V-3 prong

Gas type

Natural gas 15 mbar (USA)

1 three-ring wok burner (300 W - 5,500 W) 1,000 - 18,800 BTU, suitable for pots up to max. 12 5/8"

2 two-ring high output burners (165 W - 4000 W), suitable for pots up to max. 11".

2 two-ring standard burners (165 W - 2000 W), 570 - 13,600 BTU, suitable for pots up to max. 11".

Control knobs with illuminated
ring, cooking zone and output level markings.

One-handed operation.

Full electronic control in 12 output levels for exact power level regulation plus simmer function.

Automatic quick ignition.

Simmer function.

Three-part cast iron pan support with flat, continuous pot surface.

Brass burner rings.

Electronic flame monitoring with automatic re-ignition.

Residual heat indicator.

Safety shut-off.

Depending on the type of installation - surface-/ or flush-mounted, with or without cover - the specific location of the control knob positions may vary.

If combining several Vario appliances of the 400 series, a connection strip VA 420 must be placed between the appliances. Depending on the type of installation, the corresponding connection strip must be provided.

The bearing capacity and stability,
in the case of thin countertops in particular, must be supported using suitable substructures. Take into account the appliance weight and additional loads.

Flush installation is possible in countertops made of stone, synthetics or solid wood. Heat resistance and watertight sealing of the edges must be observed. For other materials, please consult with your countertop manufacturer.

The groove must be continuous and even, so that uniform placing of the appliance on the gasket is ensured. Do not use discontinuous lining.

The joint width may vary due to size tolerances of the combinations and of the countertop cut-out.

If installing several appliances in individual cut-outs allow for a division bar of inimum 1 " (50 mm) between the individual cut-outs.

Plan for an electrical connection (the appliance is not operable without power supply).

Air intake from above.

No intermediate shelf required.

The rear panel must consist of a non-flammable material. Wall trims must be resistant to heat.

A minimum lateral clearance of at least 12" from adjacent heat-sensitive furniture or contact surfaces must be observed or thermal insulation fitted.

Installation in a 36" wide lower cabinet is required.

The combination with VL 414 is not recommended, since the air extraction from the centre burner cannot be guaranteed due to the distance.

Minimum distance between gas cooktop(s) with more than 37,533 BTU (11kW) and ventilation hood must be 30" (76cm).

Appliance can be snapped into the worktop from above.

Total Amps: 15 A.

120 V / 60 Hz.

Total rating: 59,700 BTU. Total Amps: 2 A